Hammond manual removal

 · Two two large slotted screws on the top of the manuals hold the two manuals to each other. You do not have to remove the manuals to replace the felts, just raise them a little at the front. Remove the black rail in front of the keys and the felt is located on the rail. New felts are self adhesive so replacing is easy.  · TO GET TO THE LOWER KEYS YOU MUST LIFT THE UPPER MANUAL REMOVE THE SCREW HOLDING THE UPPER MANUAL IN To lift the upper manual you need to remove the back two. (In some A’s you may have to remove the reverb springs to be able to get at and These Models of The Hammond Organ contain the entire tone-producing.. that a new return .  · From the top, remove two big bolts (slotted, oval head). These bolts hold the drawbar base to the upper and lower manuals. There are four big hex-head bolts (entering from the bottom) which hold the manuals down into the case. To lift the upper manual you need to remove the back two.

From the top, remove two big bolts (slotted, oval head). These bolts hold the drawbar base to the upper and lower manuals. There are four big hex-head bolts (entering from the bottom) which hold the manuals down into the case. To lift the upper manual you need to remove the back two. If it is determined that a new return spring is necessary on either manual, remove the console top and music rack and take the bolts holding the manual assembly out from the bottom of the console. Raise the upper manual, or both manuals, as necessary, to gain access to the screws holding the left hand end block of the manual needing the replacement. How To Remove The Manuals Remove the rear panel of the console. Remove the four screws on the left-hand and right-hand side panels of the music rack. Lift the side panels to tilt the bottom of the rack, and then remove the rack by pulling outward. Remove the 4 chassis bolts (under the console) and.

MANUAL. 3 w. BERS. HAMMOND ORGAN COMPANY. DIVISION OF HAMMOND CORPORATION. N. 25th Avenue • Melrose Park, 3—7 Lower Manual End Blocks (Removal of). This organ took a lot of work to restore. I unsoldered the wires to remove both the upper and lower manuals. It is easier to remove the lower manual. Nov 6, The chorus generator has been removed and the original manuals have been modified to accept Vibrto / Chorus and Percussion and the later.